r/e39 • u/PlanetAtomiC • 7h ago
525i appreciation
r/e39 • u/Fearless_Lobster_858 • 9h ago
I had an engine swap done, I had a 520D and the engine and other components were taken from a 530D Touring, and I’ve noticed that the reverse lights don’t work.
Here’s what I’ve checked so far.
-fuses
-bulbs
-transmission switch
I’ve heard that the wiring on the touring is different from the sedan, and that whoever did the swap didn’t take that into consideration when wiring it.
Any ideas?
r/e39 • u/Skodakenner • 7h ago
Front jacking point is done for. But it will get welded again im far too deep into it now.
r/e39 • u/GeologistFunny5015 • 3h ago
Hey everyone!
I have a 2001 BMW E39 525d, and I’m dealing with a pretty serious coolant leak.
The car loses around 1 litre of coolant overnight.
Winter is just around the corner, and temperatures are starting to drop below freezing.
I have to drive the car to work early every morning, so leaving it parked isn’t exactly an easy option.
I currently have about 1 litre(around 1qt) of spare coolant left, but obviously that’s not going to last forever at this rate.
As you can see in the video, the coolant is dripping directly onto the belt and then running off the belt onto the ground.
What would be the smartest decision in this situation? Would you keep topping it up and drive carefully until the leak can be fixed, or stop driving it altogether?
Could the leak be coming from somewhere above the belt? Has anyone experienced something similar on their E39 M57?
Any advice or suggestions would be greatly appreciated!
r/e39 • u/TTVAccuse1x • 18h ago
I found a 98 540. I don’t know if it’s the same color but I can get the hood the fender and the radiator support for 250. Should I do it and is it the same color? Someone tell me I said about 95% cosmetic. The only part of the frame has been is the fender got pushed in a little bit and so that part of the frame got pushed in I could take a heat gun to it. What should I do?
Greetings! I’m working on replacing my ribbon cable and LCD screen. My pixelfix repair kit came with this little foam strip but I’m not sure what to do with it. Anyone done this repair before that can shed the light? They have a little video but it doesn’t show this strip being used.
TIA!

Pic for attention.
My early M52 528i was stalling at idle and running pretty rough. I found several issues like a poorly adapted crank sensor, a couple of vacuum leaks and I replaced a lot of parts like plugs, fuel filter, ICV grommet, etc. and it's running a lot better, but one issue persists:
There is a 202 code (Lambda Regulation Bank 1 Post Cat) which points to fuel trims reaching the limits but only in bank 1. I can still hear faint popping from the exhaust so it's clear the code is right.
How can I be getting mixture problems in just one bank? I've yet to replace the pre-cat O2 sensors but they're $200 each. Most people who report mixture codes naturally see two codes, one for each bank.
I'm out of fresh ideas. Should I just keep throwing money at the problem and get the O2 sensors?
r/e39 • u/CarefulLocksmith8349 • 1h ago
i made a post yesterday about some fault codes that are causing me to fail smog, one of which is P0741 (torque converter clutch circuit performance/stuck off). there is no noticeable slipping and the manual shifts work fine 1-5. either way i figure i probably need to get the torque converter changed. right now im looking at this remanufactured TC on ebay and labor in mexico a friend of a friend quoted me around 3000 pesos (160ish usd).
for anyone who’s had this problem before i have two questions:
r/e39 • u/Difficult_Push358 • 11h ago
2003 530i occasionally my ac and heat wont shut off when i remove the keys from the ignition, anyone else experience and know how to deal with this? ive had to disconnect my battery for it to shut off.