r/TpLink • • 18h ago

TP-Link - Technical Support ethernet backhaul defective.

0 Upvotes

New Deco 7 Pro Tri-Band BE14000  not using 10g ethernet backhaul. I can't find any manual way to set this up. Are there any tricks I can try before I sent it back to Amazon? Thanks.


r/TpLink • • 3h ago

TP-Link - General Any advice?

0 Upvotes

I have been struggling for DAYS now to get my wifi working on the other half of my house. I have an HB810 router, and just got a be3600 extender. Person that lives on the other half of the house is getting poor connection even with the extender. I have it in AP mode and wired to my router. Why do I have 2 extra networks with _ext? How can I just combine the into the normal router channel? Do I even want ap mode? I feel like I keep finding conflicting information.


r/TpLink • • 19h ago

TP-Link - Technical Support Defective BE 1300 unit - common or bad luck?

0 Upvotes

After 2 weeks of troubleshooting with Gemini and Claude, I gave up, and here is the summary of my router (by Gemini):

On one specific satellite node (connected via wired Ethernet backhaul), the 6 GHz radio completely falls apart under load despite sitting right next to it with a great signal:

Signal: RSSI -48 to -53 dBm, Noise -92 dBm (~44 dB SNR)

Negotiation Collapse: Link rate drops to `8 Mbps` and stays hard-locked at MCS Index 1 (NSS 1)

Real-World Speed: Downlink/Uplink tank to 29–58 Mbps with massive loaded latency (1.49s / 40 RPM on `networkQuality`)

How I Isolated It: Same node, other bands:Wired Ethernet, 2.4 GHz, and 5 GHz (160 MHz) on this exact same unit work flawlessly—negotiating at `1441–1633 Mbps` (MCS 8) and pulling 840+ Mbps down (`1200+ RPM`, 0% packet loss).

Other nodes: The other two Deco units in the same 3-pack work completely fine on both 5 GHz and 6 GHz.

Multiple clients: Reproduces identically on both an M4 Pro MacBook Pro and a Windows 11 desktop with a Qualcomm FastConnect 7800 Wi-Fi 7 card.

What I Already Tried (No Permanent Fix):

  1. Verified all nodes are on the latest firmware
  2. Tested both 320 MHz and 160 MHz channel widths on 6 GHz
  3. Disabled QoS, MLO, Fast Roaming (802.11r), Beamforming, and IPv6
  4. Ran Network Optimization, rebooted, and did a full factory reset on the node

Has anyone else seen a single Deco BE13000 / BE67 unit develop a dead or degraded 6 GHz radio like this while 5 GHz stays rock solid?


r/TpLink • • 6h ago

TP-Link - Technical Support HELP

Post image
2 Upvotes

I have this archer c54 for 3 years already. At first, it runs smoothly but recently it keeps disconnecting me and showing this red light on internet icon. But when I restarted it, it foes back to normal again even after customizing wifi name and password but after a few hours or days, it comes back like this again where i need to restart again and change wifi name and password. What do I do to stop this cycle?