We’re in NY and hired a GC for a $45K gut bathroom renovation.
The design included a 39” freestanding soaking tub inside a walk-in shower from the very beginning. This was not a last-minute addition or change in scope.
Because the shower floor slopes toward the linear drain, there’s a visible gap beneath the tub ranging from approximately 1/4” to 3/4” at its widest point.
Our GC insists this isn’t a problem. I understand the need for proper drainage, but what happens when water, soap residue, hair, and dirt accumulate in a space that’s nearly impossible to reach? The tub has not been permanently installed yet, but all the tilework is finished. I strongly believe there was miscommunication between his tile people. But maybe I am being unreasonable here.
I’d appreciate some professional opinions:
- Is this considered acceptable workmanship?
- Should the floor slope and tub placement have been accounted for during planning and construction? Or is the dimensions just too small to have made anything work?
- How can we close this gap - nuclear option is to rip out tiles and start over - but I’m looking for other options.
I’m not looking to be unreasonable. I just want to understand whether my expectations are fair and what a solution would look like.
UPDATE: Thanks for the feedback, especially the constructive advice.
A few adds
Tub: Enflair Angie Corner 39” acrylic soaking tub with a recessed base with support feet. 79.5 lbs empty, with a 73.5-gallon capacity.
Installation: The tub has adjustable feet, which have already been adjusted to accommodate the floor slope. It has not been permanently installed.
Design: There was no designer nor architect involved. We shared the vision and asked if it was possible. Devil is clearly in the details, so hard lesson learned.
Floor: Large-format 24” × 48” tiles with a linear drain. All tilework is complete.
I understand that the shower floor must slope for drainage and that the tub needs to remain level. I’m not suggesting otherwise. The gap came as a surprise, and while I’m not looking to assign blame, I don’t think leaving it as is should be our only option. This was a planned installation, and I’d like to explore a practical solution that addresses both the appearance and long-term maintenance concerns.